SINCO SF 6713 Manual Del Usuario página 6

SINBO SF 6713 STAND FAN
INSTRUCTION MANUAL
TECHNICAL SPECIFICATION: AC230V, 50Hz, 45W
ASSEMBLING INSTRUCTION
Oscillation knob
Motor
Control box
Power cord
Screw B
Extension tube
Out – joint
Stand cover
Stand base
FOR STAND FAN:
1. Put spring in stand tube from the tube bottom, tighten stand tube to stand base with
screw A.
2. Unscrew the base screw by turning clockwise from the stand pole, and put the base
screw through the cross base to stand pole by turning counter clockwise then tighten
the base and the extenslon pole.
3. Put the base cover on the stand base. Pull the extenslon pole out then tighlen the out
– joint again.
4. Place control box firmly on top of extension pole, tighten sorow B.
For remote control model:
1. You just push the only buton and you could choose the high speed, medlum spead, low
speed or stop easily.
2. You remove the covar from the back of the remote controller, and put the two batteries,
aim it at switch board when operating the remove controller.
ENGLISH
Front gril
Blade
Rear gril
Shaft
Nut
Switch
Screw A
Rubber foot
- 5 -
Cap
1. Extension tube
2. Out – joint
3. Stand
4. Front base
5. Base
6. Fixing plate
7. Screw shaft
Plastic foot