Weighing; Adding & Weighing (Tare Function); Removing Weighed Items; Setting The Timer - Silvercrest KH 1157 Instrucciones De Uso

➩ To switch within a measurement system,
g/kg - ml water - ml milk
oz/lb:oz - fl´oz water - fl´oz milk
briefly press the sensor area UNIT
desired measurement unit appears in the display
e
.

Weighing

➩ Press the sensor area ON/OFF
scales on (weighing mode).
➩ Programme in the desired measurement unit
(see chapter "Setting the units of measurement").
The scales indicate a weight of "0". In the left of the
e
display a "O" is indicated.
➩ Place a suitable receptacle on the scales and
press the sensor area Z/T
again show "0", it does not take account of the
weight of the receptacle.
➩ Place the item(s) to be weighed in the receptacle.
Adding & Weighing (Tare Function)
You can repeatedly set the scale back to "0" in order
to weigh additional partial quantities.
➩ Press the sensor area Z/T
e
the display appears „TARE". The scales indi-
cate a weight of "0" again.
➩ Place the additional item(s) to be weighed in the
receptacle.
The weight of the newly inserted item(s) is shown in
the display e .
You can repeat this procedure several times.
However, never place more than 5 kg on the
scale.
When you take all of the weighed items from the
scales and press on the sensor area Z/T
"O" is indicated in the left of the display
or
u until the
t
to switch the
y
. The scales once
y
once. In the left of
y
e

Removing Weighed Items

➩ Press the sensor area Z/T
indicated in the left of the display
The scales indicate a weight of "0" again.
➩ Remove the desired amount of material.
The weight value of the removed material appears
in the display
You can repeat this procedure several times.
When you take all of the weighed items from the
scales and press on the sensor area Z/T
"O" is indicated in the left of the display

Setting the Timer

The timer can be used in both a clock and weighing
mode.
The timer enables you to set the clock for a specific
period of time, at the end of which a signal tone
sounds. The preset time runs as in a countdown
➩ Press the sensor area T-SET
play e the bell symbol
left.
You can adjust the time accurately to the second.
If you hold your finger on the sensor area ▲
or ▼ UNIT
y
Z/T
through faster.
➩ Using the sensor areas ▲ Z/T
programme in the desired ten-minute setting.
➩ Press the sensor area T-SET
sensor areas ▲ Z/T
in the desired single-minute setting.
➩ Press the sensor area T-SET
sensor areas ▲ Z/T
in the desired ten-second setting.
➩ Press the sensor area T-SET
sensor areas ▲ Z/T
, in the desired single-second setting.
➩ Press the sensor area T-SET
.
down.
- 26 -
y
once. "TARE" is
e
as a negative value.
i once. In the dis-
appears at above-
u
, the time-indicators run
y
i
once. Using the
or ▼ UNIT
y
i once. Using the
or ▼ UNIT
y
i once. Using the
or ▼ UNIT
y
i
to start the count-
e
.
y
,
e .
or ▼ UNIT
u
u
programme
u
programme
u programme