Stadler Form Eva Manual De Instrucciones página 13

air can no longer absorb the moisture from the humidifier. Please activate
the auto mode with a desired humidity of 45 %. Water droplets should then
stop forming.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (1) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
If pre-heating is turned on (the warm mode LED is on (13)), the water inside
the appliance is heated: the water in the water tray (9) and the heating plate
(17) become hot. Avoid touching the water and the heating plate!
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Run the cleaning mode at least once per month. The appliance must
be off for at least 15 minutes prior to internal cleaning! Then remove the
water tank (6), the mist chamber (23), the silicone cover (18), the Water
cube (24) and the fragrance container (20). Fill a cup with 6.6 fl. oz. / 200 ml
of tap water mixed with descaling agent (mix according to the manufac-
turer's instructions). Pour the liquid carefully into the water tray (9) by
holding the cup directly over the water tray (see page 5). Do not pour the
liquid into the water tray from high above the tray! Be sure that no liquid
enters the air inlet opening (26). This will damage the appliance and will
void any claim to the warranty.
• To start the cleaning mode, the mains cable must be connected to a sock-
et. Press and hold the night mode button (21) on the underside of the right
corner for 5 seconds to activate the cleaning mode. Now the water level
symbol (16) on the appliance will blink red. The cleaning mode runs for
around 5 minutes and automatically turns off afterwards (the water level
symbol stops blinking).
• Check in the water tray (9) if the limescale on the ultrasonic membrane
(19) and the heating plate (17) has dissolved. Attention: the water and
the heating plate are hot, risk of scalding!
• If limescale residue remains, the ultrasonic membrane (19) and the heat-
ing plate (17) can be cleaned with the help of the cleaning brush (25)
(front- and backside). Do not try to scrape them with a hard object.
• For stubborn limescale, we recommend descaling the appliance by run-
ning the cleaning mode (21) several times in a row. Leave the descaling
agent in the water tray for a maximum of 20 minutes and pour it out after-
wards as described below.
• Important: Pour the descaling agent out over the left front corner of the
appliance (see the arrow on the appliance). No water may enter the air
inlet opening (26). This will damage the appliance and will void any claim
to the warranty.
• To rinse, now fill the cup with 6.6 fl. oz. / 200 ml of tap water and carefully
pour the liquid into the water tray (9) by holding the cup directly over the
water tray (see page 5). Do not pour the liquid into the water tray from
high above the tray! Pour the water out over the left front corner of the ap-
pliance. Repeat the process until there is no more descaling agent in the
water tray (9). Place the Water cube (24), silicone cover (18), mist chamber
(23), water tank (6) and fragrance container (20) back into the appliance.
If the water tank is not sitting right, check if the upper part of the mist
chamber (23) is properly mounted.