Slope Match - Wacker HAL 300 Manual De Operación

Wacker HAL 300
3.7

Slope Match

See Graphic: wc_gr004599
3.7.1
3.7.1
3.7.2
3.7.3
3.7.4
3.7.5
3.7.1
3.7.2
3.7.3
3.7.4
3.7.5
3.7.6
wc_tx000803gb.fm
All manuals and user guides at all-guides.com
The laser can be used to match manual slope on both X and Y axes.
Two modes are available:
• Complete manual mode: X and Y axis will be both manual
• Semi-automatic mode: Y in automatic / X in manual
Semi-automatic mode
Set the laser over a start point.
Turn the laser so that the side of the laser with the handle, +X, faces
the direction of the slope (and -X faces away; see axis direction in
"Maintenance"). Use the sighting groove on the top of the housing to
roughly align the X axis of the laser to the second point.
After turning the laser on and allowing it to self-level, hold the MAN/
AUTO key (7) for a few seconds until the X LED (11) is lit continually.
The laser is now in manual mode in X axis and automatic self-leveling
mode in Y axis.
Press ^ (5) on the keypad to match a positive slope in X and v (6) to
match a negative slope; the Y axis will stay level.
Press twice on the MAN/AUTO key to return to the automatic mode.
Manual Mode
Set the laser over a start point.
Turn the laser so that the side of the laser with the handle, +X, faces
the direction of the slope (and -X' faces away; see axis direction in
"Maintenance"). Use the sighting groove on the top of the housing to
roughly align the X axis of the laser to the second point.
After turning the laser on and allowing it to self-level, hold the MAN/
AUTO key (7). The X LED (11) will blink, indicating the laser is now in
manual mode and can match slope in the in X axis.
Press ^ (5) on the keypad to match a positive slope in X and v (6) to
match a negative slope.
To switch to the Y axis, press the H.I. key (8). Both LEDs will blink,
indicating you're in manual mode and can match slope in the Y axis.
Press ^ (5) on the keypad to match a positive slope in Y and v (6) to
match a negative slope. Press on the MAN/AUTO key to return to the
automatic mode.
Note: The Y axis grade will be at a 90° angle from the X axis grade
output.
In manual mode, the beam rotates even if the laser is not leveled. The
H.I. Alert function is not available when the unit is in manual mode.
EN-11
Operation