Before Use; Selecting The Grinding Disc; Changing Sanding Sheets; Dust / Swarf Removal By Suction - Parkside PDEXS 150 A1 Instrucciones De Utilización Y De Seguridad

before use

Selecting the Grinding Disc

Metal removal and Surface:
The rate of metal removal and the surface quality
are determined by the grain size of the grinding disc.
lease note that corresponding grinding discs
with different grain sizes should be used for
processing different materials.

Changing sanding sheets

The air sander is fitted with a hook and loop fastening,
which allows for quick and easy replacement of
sanding discs.
Lift the grinding disc at the side and pull it off
from the backing pad
note: Before securing a new sanding sheet, re-
move all dust and dirt from the sander plate
Ensure that the openings in the sanding sheet
concur with the boreholes of the sanding plate

Dust / Swarf removal by Suction

Please note the "Safety instructions" section.
Using the internal vacuum extraction
with dust collection device (see Fig. b):
Push the exhaust air hose
connection for dust extraction
ing of the dust bag
10
exhaust air hose and fasten the dust bag
9
firmly in position.
note: Empty the dust bag
regularly to ensure optimum dust extraction. To
do this open the zip fastener on the underside
of the dust bag .
10

Topping up the oil

In order for the air sander to have a long service life,
there must always be enough pneumatic oil in the
device.
All manuals and user guides at all-guides.com
in order to remove it.
6
.
6
.
6
fully on to the
9
. Put the open-
2
over the free end of the
10
in good time and
10
Before use / Preparing for use
You may ensure this in any of the
following ways:
Connect a service unit with an oiler to the
compressor.
Install a line oiler in the compressed air line or
at the compressed air device.
Put approx. 3–5 drops of pneumatic oil by
hand into the plug nipple
of operation.

Preparing for use

Connecting the compressed
air source
note: The air sander must be operated using
cleaned and condensate-free compressed air only
and its maximum allowable working pressure of
6.3 bar at the device must not be exceeded.
note: The compressed air source must be fitted with
a (filter) pressure reducer so that the air pressure can
be regulated.
Connect the plug nipple
coupler to the compressed air supply.

Switching on and off

note: Always switch on the air sander before
bringing it into contact with the workpiece material.
Switching on the air sander:
Press the operator's lever
(see Fig. C).
Set the speed using the speed control
Switching off the air sander:
Release the operator's lever
After you finish work, disconnect the device
from the compressed air source.
note: First disconnect the hose from the com-
pressed air source (compressor) and only then
disconnect the compressed air supply hose
from the device. This will ensure that the com-
pressed air supply hose does not wave around
in an uncontrolled manner.
every 15 minutes
3
by a quick-release
3
fully down
1
.
5
.
1
GB/MT 33