Spindle Speed In R.P.M - RIDGID DP1550 Manual Del Propietário

Spindle Speed in R.P.M.

1. Drill Speed Table...Drill Speed can be
changed by placing the belt in any one
of the stepped pulleys. The spindle
speed chart, as shown above, lists
belt positions for the various spindle
speeds.
2. Belt Guard...Covers pulleys and belt
during operation of drill press.
3. Belt Tension Lock Handle...Tighten-
ing handle locks motor bracket sup-
port to maintain correct belt distance
and tension.
4. Belt Tension Handle...Turn handle
counterclockwise to apply tension to
belt, turn handle clockwise to release
belt tension. Refer to section "Assem-
bly-Installing and Tensioning Belt".
5. Head Lock Set Screws...Lock the
head to the column. Always have them
locked in place while operating the drill
press.
6. Feed Handle...For moving the chuck up
or down. One or two of the handles may
be removed if necessary whenever the
workpiece is of such unusual shape that
it interferes with the handles.
7. Column Collar... Holds the rack to the
column. Rack remains movable in col-
lar to permit table support movements.
8. Table Support...Travels up and down
on column. Supports arm and crank.
9. Table Crank...Turn clockwise to ele-
vate table. Support lock must be
released before operating crank.
10. Rack...Combines with gear mecha-
nism to provide easy elevation of table
by hand operated table crank.
All manuals and user guides at all-guides.com
11. Base...Supports drill press. For addi-
12. Column Support...Supports column,
13. Column...Connects head, table and
14. Table...Provides working surface to
15. Depth Scale...Shows depth of hole
16. Depth
17. Depth Scale Lock...Locks the depth
18. Spring Asm....Provides means to
19. Belt Guard Latch...Press button to
20. Chuck...Holds drill bit or other recom-
21. Arm...Extends beyond table support
22. Table Bevel Lock...Locks the table in
23. Table Lock...Table can be rotated in
24. Bevel Scale...Shows degree table is
25
tional stability, holes are provided in
base to bolt drill press to floor. (See
"Additional Safety Instructions for Drill
Presses".
guides rack, and provides mounting
holes for column to base.
base on a one-piece tube for easy
alignment and movement.
support workpiece.
being drilled in inches and millimeters.
Scale Indicator...Indicates
drilling depth selected on depth scale.
scale to selected depth.
adjust quill spring tension.
raise belt guard.
mended accessory to perform desired
operations.
for mounting aligning the table.
any position from 0°- 45°.
various positions and locked.
tilted for bevel operations. Scale is
mounted on table support, if it is to be
used for quick reference where accu-
racy is not critical.