Tilting Table; Hole Location; Feeding - RIDGID DP1550 Manual Del Propietário

Ocultar thumbs Ver también para DP1550:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Basic Drill Press Operation (continued)

Tilting Table

To use the table in a bevel (tilted) position,
loosen the set screw under table bevel
lock with hex "L" wrench. Loosen bevel
lock bolt with the 24mm flat wrench
(included).
Tilt table to desired angle by reading bevel
scale. Retighten bevel lock and set screw.
WARNING: To reduce the risk of
injury from spinning work or tool
breakage, always clamp work-
piece and backup material
securely to table before operat-
ing drill press with the table
tilted.
To return table to original position: Loosen
set screw and bevel lock, tilt table back to
0° on bevel scale and retighten set screw,
then tighten bevel lock.

Hole Location

Make a dent in the workpiece where you
want the hole, using a center punch or a
sharp nail.
Before turning the switch on, bring the drill
down to the workpiece lining it up with the
hole location.

Feeding

Pull down on the feed handles with only
enough effort to allow the drill to cut.
Feeding too slowly might cause the drill to
burn. Feeding too rapidly might stop the
motor, cause the belt or drill to slip, tear
the workpiece loose or break the drill bit.
When drilling metal, it may be necessary
to lubricate the tip of the drill with cutting
oil or motor oil to prevent burning of the
drill tip.
All manuals and user guides at all-guides.com
Bevel Scale
32
Bevel Lock
Set Screw

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido