Ibiza Light STAR-LASER-BL Manual De Uso página 4

a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity
and to make sure the pins are not grounded or shorted to the shield or each other.
SETTING UP A DMX SERIAL DATA LINK
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the con-
troller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
MASTER/SLAVE FIXTURE LINKING
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the
output as stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initial-
ized for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow
may also require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete
instructions for this type of setup and configuration.
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER
Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
MENU MAP
Press the <MODE> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN>
buttons to navigate through the menu options. Press the <ENTER> button to select the menu function current-
ly displayed or to enable a menu option. To return to the previous option or menu without changing the value,
press the <MODE> button. After a few seconds, the LED Display will switch off during operation until another
button is pressed.
Addr d001-d512
18CH
CHnd
13CH
Auto
SLnd
Soun
SH 0
SH 1
SHnd
SH 2
SH 3
SEnS 0-99
OFF
LEd
ON
no
dISP
YES
4
Manual - STAR-LASER
512 address setting
18 channel settings
13 channel setting
Self running mode
Sound controlled mode
Effect 0 (recommended)
Effect 1
Effect 2
Effect 3
Voice sensitivity adjustment
Display off after 5 seconds of inactivity
Display always on
Display reverse
Display positive
©Copyright LOTRONIC 2021
8.8.8.8.
MENU UP DOWN ENTER