Drying Out; Technical Data - melitta Latticia OT Manual De Instrucciones

7.9 Drying out

During drying out, residual water is
removed from the appliance. You should
dry out the appliance whenever you do
not use it for longer periods, if you want to
transport it or if there is a risk that it could
freeze.
If the water filter is inserted, you will need
to remove it from the water tank before-
hand.
1. Simultaneously press the
"Water/Service" and "Brewing Strength"
buttons for longer than 2 seconds to
access Service mode 2.
2. Press the "Water/Service" but-
ton repeatedly until the Steam Dispens­
ing display flashes.
3. Press the "Water/Service" button
for longer than 2 seconds.
» The Water display lights up.
4. Remove the water tank.
» The drying out process begins.
» The appliance switches off.
5. Insert the empty water tank.
Keep the water filter in a vessel containing
tap water in the refrigerator so that it does
not stand dry over a longer period.
8 Transport
Transport the appliance in the original
packaging if possible.
You may not fasten loose parts with
adhesive tape or parcel tape because the
adhesive residue is difficult to remove.
When you send the appliance to Melitta's
service centres, you do not need to send
in the cup plate. This prevents scratches
during transport.
Before transporting the appliance, you
must carry out the following activities:
Dry out the appliance (see section 7.9,
ƒ
page 31).
Empty the drip tray and the coffee
ƒ
grounds container.
Empty the water tank.
ƒ
Empty the bean container.
ƒ
Clean the appliance (see section 7,
ƒ
page 26).
Package the appliance.
ƒ
9 Disposal
Appliances marked with this sym-
bol are subject to the European
Directive 2012/19 / EC for WEEE
(Waste Electrical and Electronic
Equipment).
Electrical appliances do not belong in
domestic waste. Dispose of the appliance
in an environmentally friendly way via
suitable collection systems.

10 Technical data

Technical data
Operating voltage 220 V to 240 V, 50 Hz to 60 Hz
Power consumption Maximum 1450 W
Pump pressure Static, max. 15 bar
Dimensions
Width 200 mm
Height 352 mm
Depth 459 mm
Holding capacity
Bean container 250 g
Water tank 1.5 l
Weight (empty) 7.7 kg
Ambient conditions
Temperature 10°C to 32°C
Relative humidity 30% to 80%
(non-condensing)
11 Troubleshooting
Contact our hotline if the actions listed in
the table fail to rectify the problems or if
other problems not listed here occur.
You will find the telephone numbers (local
rates) in the lid of the water tank or in the
Service section on our website.
Transport
31