Factory Settings - melitta Latticia OT Manual De Instrucciones

Care and maintenance
Use the screwing aid to screw the water
filter into and out of the water tank.
Inserting/changing water filter
Place a new water filter in a vessel filled
with fresh tap water for a few minutes.
The Filter display light asks you to change
the water filter.
1. Press the "Water/Service" button
for longer than 2 seconds to access
Service mode 1.
2. Press the "Water/Service" button
repeatedly until the Filter display lights
up.
3. Press the "Brewing Strength"
button repeatedly until one coffee bean
is lit.
4. Press the "Water/Service" button
for longer than 2 seconds.
» The filter program starts. The Filter
display flashes for the duration of the
program.
» The Drip tray display lights up.
5. Empty the drip tray and the coffee
grounds container.
6. Insert the drip tray without the coffee
grounds container and place the coffee
grounds container under the outlet.
» The Water display lights up.
7. Empty the water tank.
8. Insert a new filter in the water tank.
9. Fill the water tank with fresh tap water.
10. Insert the water tank.
» The filter is rinsed.
11. Empty the coffee grounds container.
30
12. Insert the drip tray with the coffee
grounds container.
» The appliance is ready for operation.
Removing the water filter
1. Remove the water filter from the water
tank.
2. Fill the water tank with fresh tap water.
3. Insert the water tank.
4. Press the "Water/Service" button
for longer than 2 seconds to access
Service mode 1.
5. Press the "Water/Service" button
repeatedly until the Filter display lights
up.
6. Press the "Brewing Strength"
button repeatedly until no coffee beans
are lit.
7. Press the "Water/Service" button
for more than 2 seconds to save the
setting and exit service mode.
» The water filter is de-registered.
8. Set the water hardness (see section 6.2,
page 25).

7.8 Factory settings

The appliance can be reset to the factory
settings. In this case, all personal settings
are lost.
1. Simultaneously press the
"Water/Service" and "Brewing Strength"
buttons for longer than 2 seconds to
access Service mode 2.
2. Press the "Water/Service"
button repeatedly until the 2x display
flashes.
3. Press the "Brewing Strength"
button repeatedly until one coffee bean
is lit.
4. Press the "Water/Service" button
for more than 2 seconds to reset the
appliance to the factory settings and
exit service mode.
Press any direct key to exit service mode
without resetting the factory settings.