On/Off" Button; Service Modes; First Steps; Unpacking The Appliance - melitta Latticia OT Manual De Instrucciones

First steps

2.1 "On/Off" button

Switch on the appliance by briefly pressing
the "On/Off" button. The appliance per-
forms automatic rinsing while it heats up.
Place a vessel under the outlet if possible.
You can switch off the appliance by press-
ing the "On/Off" button for approximately
2 seconds. If you do not switch off the
appliance, it will switch off automatically
after a defined off time.

2.2 Service modes

The appliance has two service modes. The
service modes allow you to configure your
appliance and use care and maintenance
functions.
Calling up service mode
Press the "Water/Service" button
ƒ
for longer than 2 seconds to access
Service mode 1.
Simultaneously press the
"Water/Service" and "Brewing Strength"
buttons for longer than 2 seconds to
access Service mode 2.
» The Ready display flashes rapidly
when the service mode is active.
Press the "Water/Service" but-
ƒ
ton once or several times to select a
function.
» The display for the active function is
lit up.
If no further input is made within 1 minute,
the appliance returns to Ready mode.
Ending service mode
Press the "Water/Service" button
ƒ
for more than 2 seconds to save the
setting and exit service mode.
Press any direct key to exit service mode
ƒ
without saving the setting.
3 First steps

3.1 Unpacking the appliance

Remove the packaging material, the adhe-
sive strips and the protective films from
22
the appliance. Please keep the original
packaging.
The appliance has been tested in the
factory to ensure that it functions perfectly.
Therefore, the appliance may still contain
traces of coffee and water.
Included in delivery
Milk hose
ƒ
Screwing aid for the water filter
ƒ
Test strip for determining the water
ƒ
hardness

3.2 Setting up the appliance

Set up the appliance in a dry room.
ƒ
Set up the appliance on a stable, flat
ƒ
and dry surface. The surface may not be
hot. The appliance may not be placed in
the vicinity of sinks or the like.
Set up the appliance at a sufficient
ƒ
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
Route the power cable so it does not lie
ƒ
over edges or cannot be damaged by
hot surfaces.

3.3 Connecting the appliance

Only connect the appliance to a properly
installed earthing contact socket. The
earthing contact socket must be protected
by a fuse with a rating of at least 10 A.
3.4 Switching on the appliance
for the first time
1. Place a vessel under the height-adjust-
able outlet. The distance between the
outlet and the vessel should be as small
as possible.
2. Switch on the appliance with the "On/
Off" button.
» The Ready display lights up briefly.
» The Water display lights up.
3. Remove the water tank. Rinse out the
water tank with clean tap water.
4. Fill the water tank with fresh, cold tap
water and insert it. Observe the instruc-
tions in section 4.1, page 23.