Erase; Quick Erase - U-Reach NV-BM Serie Manual Del Usuario

3.1 Source Port
Scroll to select "3. 1 Source Port", then press "OK" to copy to and verify targets from the
source port.
3.2 Internal Storage
Scroll to select "3. 2 Internal Storage" , then press "OK" to select which GOB Image to copy
and verify from the duplicator's built-in storage device. The GOB Image is created through
U-Reach's proprietary software that is included with the duplicator.
1. When "1.2 Internal Storage" is selected, the 1
automatically (e.g. NV-BM60 will become 1-6 duplicator). Please use the
Caution
duplicator carefully as the manufacturer will not held responsible for any data
loss.
2. The GOB Image (internal storage) will not copy to smaller target capacities.

4. Erase

There are 4 submenu modes.
Caution Please backup all important data before using this function.
Step 1: Connect device(s) for sanitizing.
Source Port is disabled for erasing. Go to 6.6 Advanced Setup, scroll to select
Note
Erase Master function to enable source port erasing.
Step 2: Enter function "4. Erase"
Scroll to select "4. Erase", then press "OK" to view the 6 submenus.

4.1 Quick Erase

This function will erase the index table from the connected device(s).
Scroll to select "4.1 Quick Erase", then press "OK" to start the erasing process.
4.2 Full Erase
This function will erase all data per NIST 800-88 Standards to the connected device(s).
Scroll to select "4.2 Full Erase", then press "OK" to start the erasing process.
(Available when internal SSD is installed)
st
port becomes a target port
14