Removing The Collected Water - Black and Decker BD22MWSA Manual De Instrucciones

SET UP & USE
REMOVING THE COLLECTED
WATER
There are three ways to remove
collected water.
1. Use the bucket
• When the unit is off, if the bucket is
full, the Full indicator light will light.
• When the unit is on, if the bucket is
full, the compressor and the fan turn
off, and the Full indicator light will
light, the digital display shows P2.
• Slowly pull out the bucket. Grip
the left and right handles securely,
and carefully pull out straight so
water does not spill. Do not put the
bucket on the floor because the
bottom of the bucket is uneven.
Otherwise the bucket will fall and
cause the water to spill.
• Throw away the water and replace
the bucket. The bucket must be in
right place and securely seated for
the dehumidifier to operate.
• The machine will re-start when the
bucket is restored in its correct
position.
a. Pull out the bucket a little.
b. Hold both sides of the bucket with
even strength, and pull it out from
the unit.
c. Pour the water out.
Pump hose drops
NOTE:
• When you remove the bucket, do not
touch any parts inside of the unit.
Doing so may damage the product.
• Be sure to push the bucket gently all
the way into the unit. Banging the
bucket against anything or failing to
push it in securely may cause the unit
not to operate.
• If the pump hose drops when you
remove the bucket, you must reinstall
the pump hose properly to the unit
before replacing the bucket into the
unit.
• When you remove the bucket, if
there is some water in the unit you
must dry it.
• When the unit is on, if the bucket is
removed, the compressor and the
fan turn off, then the unit will beep 8
times and the digital display shows
Eb.
• When the unit is off, if the bucket is
removed, the unit will beep 8 times
and the digital display shows Eb.
Reinstall pump
hose properly
Page 11