Operation Instructions - Black and Decker BD22MWSA Manual De Instrucciones

SET UP & USE
FILTER
The check filter feature is a reminder
to clean the Air Filter for more efficient
operation. The Filter indicator light will
illuminate after 250 hours of operation.
Clean the filter with warm, soapy water
and dry thoroughly before putting
back in place. Once filter is back in the
unit, press the FILTER button to reset
the filter indicator.
CAUTION: Do not operate the
dehumidifier without the
included filter in place.
Unit should be turned off
and unplugged to change
filter.
TURBO BUTTON
Control the fan speed. Press to select
either High or Low fan speed. Set
the fan control to High for maximum
moisture removal. When the humidity
has been reduced and quiet operation
is preferred, set the fan control to Low.
CONTINUE BUTTON
Press to activate the continuous
dehumidifying operation. This function
will keep the unit operating without
having to empty the bucket. For this
function, the drain hose will need to be
attached to the back of the unit.
TIMER BUTTON
Press to initiate the Auto start and
Auto stop feature, in conjunction with
the and buttons.
INCREASE/DECREASE BUTTONS
Humidity Set Control buttons
The humidity level can be set within a
range of 35% RH (Relative Humidity)
to 85%RH (Relative Humidity) in 5%
increments. For drier air, press the
button and set to a lower percent
value (%). For damper air, press the
button and set a higher percent value
(%).
Timer Set Control buttons
Use the Up/Down buttons to set the
Auto start and Auto stop time from
0.0 to 24.
POWER BUTTON
Press to turn the dehumidifier on and
off.
COMFORT BUTTON
Press to start/stop the comfort
dehumidifying operation. This function
will automatically adjust the humidity
level based on the temperature of the
room. The humidity level cannot be
adjusted in this setting, it will stabilize
between 45%-55%. Press the comfort
button or the humidity adjust buttons
to cancel this feature.
PUMP BUTTON (only
BD50PMWSA)
Press to activate the pump operation.
NOTE: Make sure the pump drain
hose is installed into the unit
before the pump operation is
activated. When the bucket is
full,the pump starts to work.
Refer to the next pages for
removing the collected water.
Do not use this operation
when the outdoor temperature
is equal to or less than 32˚F
(0˚C).
DISPLAY
Shows the set % humidity level from
35% to 85% or auto start/stop time
(0~24) while setting, then shows
the actual (±5% accuracy) room %
humidity level in a range of 30% RH
(Relative Humidity) to 90%RH.
Page 9