ProMed 4030 SX Manual De Instrucciones página 28

I
NSTALLATION
DE
After removing the packaging, take the following steps before
US
getting started:
FR
1. Before getting started, please check that the package is
complete and that the voltage matches that of the local
IT
supply (operating voltage 230V or 115V connected to an
ES
alternating current at a mains outlet installed in confor-
mance with regulations). The unit is supplied with a dust
NL
filter already installed in the filter chamber. You can check
this by removing the chamber cover
RU
PL
2. Make sure you set up the unit on a level surface and ensure
that the ventilation slits at the back of the unit are not ob-
SE
structed. There should also be enough room behind the unit
to allow sufficient air circulation. The environment should be
FI
3. First connect the vacuum hose
(pull out the knob).
(14)
4. Attaching / changing bits:
dry and of a normal temperature and humidity (do not set up
the unit in the direct vicinity of heat sources or humidifiers).
filter chamber cover (press the connection piece in firm-
(12)
ly), then attach the motor connector to the „Motor" socket
on the front of the unit (insert the connector at an angle
(13)
and twist it to the right to lock. The opposite applies when
un-plugging).
Always switch off the motor when attaching or changing
bits. First choose a suitable bit. Attach the bit to the connec-
tor on the end of the hand unit. A new quick-release mecha-
nism allows you to change instruments without having to turn
to the opening on the
(11)