Cable Requirements; Intended Use - Grundfos LC 232 Manual Del Usuario

Tabla de contenido

Publicidad

English (GB) Safety instructions
Original safety instructions
These safety instructions give a quick overview of the safety precautions to be taken in connection with any work
on this product. Observe these safety instructions during handling, installation, operation, maintenance, service
and repair of this product. These safety instructions are a supplementary document, and all safety instructions
will appear again in the relevant sections of the installation and operating instructions. Keep these safety
instructions at the installation site for future reference.

Cable requirements

WARNING
Electric shock
Death or serious personal injury
The wires from the pump phases must be rated at 90 °C (194 °F).
The wires from the temperature sensor, if any, must be rated at 480 V and 70 °C (158 °F).
Connecting the pump supply and power supply
DANGER
Electric shock
Death or serious personal injury
In case of an insulation fault, the fault current may be a DC or pulsating DC. Observe national
legislation about requirements for and selection of Residual Current Device (RCD) when installing
the control unit.
WARNING
Electric shock
Death or serious personal injury
Switch off the power supply before making any electrical connections.Make sure that the power
supply cannot be switched on accidentally.
Remember to indicate where the main switch is located by placing a label or similar marking on
the control unit.
Make sure that the voltage between the phase and neutral does not exceed 250 VAC.
Electrical connections must be carried out according to the wiring diagrams.

Intended use

The product is designed to control one or two pumps.
The product can be configured for the following two purposes:
dewatering in groundwater supply
filling a tank.
The product can be used for the following applications:
groundwater supply
irrigation systems
small waterworks
network pumping stations
main pumping stations
commercial buildings
municipal systems.
The product must not be exposed to strong solvents or oil-containing liquids.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido