Technical Specifications - Urmet 1039/44 Guia De Inicio Rapido

ENGLISH
The switch Ref. 1039/44 is provided with Power
over Ethernet (PoE) feature: it has 8 ports and can
work in Fast Ethernet at 100Mbps or Ethernet at
10Mbps.
Ports from 1 to 4 use PoE standard and automatically
detect the presence of PoE compatible devices.
The switch supplies a total of 53W to the 4 PoE
ports for powering all the PoE standard devices in
the Ipercom system.
Use CAT5 cable with Urmet RJ45
connectors for connecting the devices
to the switch.

TECHNICAL SPECIFICATIONS

SWITCHING ADAPTER
1,4 A @ 100 - 240Vac ~ 50/60Hz
Power supply:
Output current:
SWITCH
Input current:
Total number of ports:
PoE input voltage:
Total deliverable max power:
Operating mode:
Operating temperature:
Dimensions (L x H x D):
LED OPERATING STATE
PWR-POWER LED
On green The switch is powered
Off Switch is not powered
PoE PORT LEDS FROM 1 TO 4
PoE Active - Green LEDs
On green The PoE device is connected
to the port (from 1 to 4) and
correctly powered
Off No PoE device connected to
the port (from 1 to 4)
DS1039-056
1,25 A @ 48 V
1,25 A @ 48 V
4 + 4 PoE
48 V (15,4 W for PoE port)
53 W max on all ports
Fast Ethernet at 100Mbps
Ethernet at 10 Mbps
0 ÷ 40 °C
236 x 27 x 102 mm
PoE Fault - Yellow LEDs
On yellow This
following problems is presents
and the port (from 1 to 4) is not
powered:
•
•
Off The
correctly
PoE Max - Yellow LED
On yellow This indicates that the available
PoE power is less than 7W
Yellow blinking This indicates that the Max
PoE LED was active during the
previous two minutes
Off The PoE ports are working
normally
Green Ethernet Ports LEDs (Ports from 1 to 8)
On green Port connection is working
correctly
Green blinking Data transmission/reception
Off No connection
indicates one
Short-circuit to line
The required power exceeds
the available limit
PoE port is
of the
working
3