Instructions For Use; Start And Stop - IPC Soteco FOX Manual De Instrucciones

3. Instructions for use

Before using the machine make sure
that the voltage shown on the rating
plate on tank corresponds with the
mains voltage.

3.1 Start and stop

Start
1. Pull out the cord (7) and plug
the machine to a wall socket.
2. Press the on/off button (5)
Stop
1. Turn off the machine (5) and
unplug.
2. Unplug by grasping the plug,
not by pulling on the cord.
3.2 Pre-filter Cleaning
The pre-filter (11) needs to be cleaned
from time to time with the built in
automatic filter cleaning system. The
pre-filter (11) needs to be cleaned
when the suction
decreases and
noise increases.
Pre-filter cleaning
1. Turn the machine on.
2. Make sure that the air intake
on the hand tube is closed
3. Put the hand tube (4) into the
holder (9) and thereby closing
for the air-flow. Motor builds
up maximum under pressure in
the tank.
4. Push the filer cleaning button
(12) 4-5 times.
5. Remove the hand tube (4) from
the holder (9)
18
performance
consequently motor
6. Make sure that the air intake
on the hand tube is closed.
Suction
restored
3.3 Emptying of tank
Observe whether the tank needs to be
emptied by opening the buckles (3)
and remove the vacuum cleaner head
(1).
Emptying of tank
1. Find an appropriate waste bin
outside for disposal of the tank
2. Open the buckles (3)
3. Remove the hose (10)
4. Take of the head (1) and put it
on the
appropriate feet.
5. Empty the tank (2) into the bin
6. Put the head (1) on the tank
(2) and tighten the buckles (3)
7. Clean the post-filter (see next
section)
3.4 Post-filter Cleaning
The post filter (6) ensures that very
fine dust not removed by the pre-filter
(3) is removed.
Post-filter cleaning
1. Move the latch (14) down and
take out the filter (6).
2. Clean the
outside
backwards through it and/or
move it rapidly up and down.
3. Insert the post-filter (6) into
the head (1). Ensure that it is
correctly fitted
EN
performance
ground on the
post-filter
by blowing
is
(6)
air