Chef's Grill IR-TEC IR2818-1 Manual Del Usuario página 9

Ignitor Lighting the Grill
1. Read instructions before lighting your grill.
2. Open lid during lighting.
3. Open LP cylinder or natural gas valve.
4. Push any burner control knob in and turn the knob to the left
to "HI" position. Keep pressing the knob until the burner is
lit.
5. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes for gas to clear away, and repeat
the lighting procedure.
6. To light other burners, repeat step 4.
NOTE: If ignitor does not work, follow Match Lighting
instructions.
Turn off controls and tank or gas supply when not
in use.
Please make sure the drip tray and drip cup are
properly installed before turning burners on.
Drip tray is hot when burner is on and after grilling.
Do not touch the drip tray when it is hot.
If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes, and repeat the lighting
If the burner does not ignite with
procedure.
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of
injury.
All manuals and user guides at all-guides.com
Main Burner Match Lighting
1. Open lid during lighting.
2. Place match into match holder (hanging from side of cart).
3. Push in and turn right knob to HIGH position. Be sure burner
4. Light other burners by pushing knob in and turning to HI
Side Burner Match Lighting
1. Open side burner lid. Turn on gas at LP cylinder.
2. Place match into match holder. Light match. Place lit match
3. Turn side burner knob to HI. Be sure burner lights and stays
Burner Flame Check
•Remove cooking grates and heat diffusers. Light burners,
rotate knobs from HIGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use.
9
Do not lean over grill while lighting.
Light match, place into the firebox.
lights and stays lit.
position.
near burner.
lit.