After Use; Troubleshooting - Dräger UCF 6000 Instrucciones De Uso

4.4

After use

Clean and inspect the thermal imaging camera after each use (see
chapter 6.1 on page 38 and chapter 6.2 on page 38).
The rechargeable battery should be charged and left in the charger
when not in use (see chapter 4.2.2 on page 32).
5

Troubleshooting

Fault Possible cause
The camera cannot The battery is empty. Recharge the battery.
be switched on.
The battery screws
are loose.
Laser pointer is weak Water droplets or dirt
or diffused. is on the laser emis-
sion window.
Dräger UCF 6000/7000
Fault
The charger LEDs in-
dicate an error during
the charging process.
Remedy
Tighten screws.
Clean the laser emis-
sion window.
Troubleshooting
Possible cause Remedy
The contacts on the Clean contacts with a
battery and/or the lint-free cloth.
charger are dirty.
The battery is too cold Leave the battery in
or too hot. the charger and place
charger in an area
with an ambient tem-
perature between 10
and 35 °C (50 °F and
95 °F). The charger
will charge the battery
once the temperature
inside of the charger
is correct.
It may take longer
than an hour for the
internal temperature
to reach the required
setting and charging
resumes since the
temperature is mea-
sured directly on the
li-ion cells.
37