Description Of The Installation Brackets - Midland BT City Manual Del Usuario

All manuals and user guides at all-guides.com
your mouth. This type of microphone is suited for Open Faced and Flip
Front helmets.
Wire microphone
Using the Velcro/adhesive strip, place the microphone inside the hel-
met in front of your mouth. This type of microphone is more suited
for Full Faced helmets. The mini connector on the microphone allows
you choose the microphone that best suits the helmet you are using.
Audio kit jack
The audio kit must then be connected to the central jack of the Mid-
land BTCity/BTEva unit using the " L" shaped connector.

Description of the installation brackets

The Midland BTCity/BTEva can be fixed onto the helmet in two dif-
ferent ways: By either using the plate with bi-adhesive strip, or the
clamp. These methods allow you to safely "fix" the BTCity/BTEva unit
onto your helmet and to remove it at any time in order to recharge
or store it.
Plate with bi-adhesive strip
The fixing plate has a bi-adhesive strip on
one of its sides. To fix the plate in place,
clean the application area on the helmet
surface, remove the bi-adhesive film and
place the fixing plate on the helmet by
keeping it contact with the surface for a
few seconds.
4
Clamp
Using the Allen Key, loosen the two screws on the clamp and place the
rear plate between the helmet padding and the external rigid protec-
tion. Then, tighten the two screws in order to firmly fix the clamp in
place. Inside the clamp is included a small plastic spacer, that can be
removed to close tigher the clamp.
Fitting and removing your Midland BTCity/BTEva
The BTCity/BTEva can be easily fitted onto the helmet by sliding it
downwards so that it fits into the slot of the selected fixing device
(plate with bi-adhesive strip or clamp). BTCity/BTEva is maintained
in position thanks to the fixing clip located on the upper section (A).
To detach the BTCity/BTEva, simply press the fixing clip and push the
unit upwards.
Spacer
A