Midland BT City Manual Del Usuario página 37

All manuals and user guides at all-guides.com
SETUP/PAIRING
Enter SETUP mode
Exit SETUP mode
Pairing a Phone
Pairing your BTCity/BTEva with another BTCity/BTEva
device
Reset all paired devices
SPECIAL SETUP CONFIGURATION
Change VOX sensitivity or disable it
Wired connection always on
Intercom and GPS
CTE International herewith declares that the product complies with the essential requirements of EC Directive 99/05/EC; the declaration of confor-
mity of the device can be consulted onto www.midlandradio.eu
Press the Control button for 7 seconds while the unit is off
While in Setup mode, double click the Control button. The Red light will turn off and
the Blue light starts flashing.
While in Setup mode, press the Control button until the LED light flash Red and Blue
alternately
While in Setup mode, press the Volume + on one unit (the light will flash Red and
Blue alternately), press the Volume- on the other unit (the light will flash Red and
Blue alternately). On a successful pairing, both light turn to Blue for one second.
While in Setup mode, long press he V olume + and he V olume -. On a successful reset,
the Blue light will turn on for two second.
While in Setup mode, press short the Control and VOL+ buttons (blue light on).
Now, press "Volume +" or "Volume-" to increase or reduce sensitivity. Double click
the Control button to visualize the VOX status. Go back to the SETUP mode (Red light
always on).
VOX STATUS (Blue light flashing):
Once = VOX disable
Twice = very low sensitivity
3 times = low sensitivity
4 times = medium sensitivity.
5 times = high sensitivity
Enabling: In "Setup" mode, press the "Volume+" and "Volume -" buttons for one
second. The blue LED will flash once.
Disabling: Follow the same procedure up described; now the blue LED will flash
twice
Disabling: Enter the " Setup" mode. Press the " Control" and " Volume -" buttons for
one second. The blue LED will flash once. To exit the " Setup"mode double press the
"Control" button.
Enabling again: Follow the same procedure up described; now the blue LED will
flash twice. To exit the " Setup"mode double press the " Control" button.
15