Aquatec Pure Bidet Manual Del Usuario página 23

5. Press STOP button B on the remote control.
• Shower procedure stops.
6. Press DRY button E on the remote control.
• Warm air dryer is activated. Dryer function stops
by pressing the "STOP" button.
7. Press CLEANSING/STOP button K and hold for more
than 4 seconds.
• The device is turned off — All displays switch off
on the control panel.
CLEANSING/MOVE and BIDET/MOVE function
operates for 90 seconds. Hip bath function operates
for 3 minutes. DRY function operates for 3 minutes.
The functions are ending with an audible beep.
Before and after each operation, the self nozzle
cleaning function runs and sanitizes the nozzle head.
Perform automatic cleansing
The automatic cleansing function is a default function for
people with disabilities, children or the elderly, in which a
complete cleansing cycle is automatically executed.
1590625-C
All manuals and user guides at all-guides.com
1. Press AUTO button F on the remote control.
• The 3rd level for water pressure, the 2nd level for
warm air dryer temperature and the last setting of
nozzle position are automatically set-up.
• The Sensor forces to set the water- and seat
temperature to "Medium", in case the temperature
were set up on the "High" position.
• A buzzer sounds when the auto cleansing function
finishes.
2. Press STOP button B on the remote control.
• The automatic cleansing process is interrupted.
3. Press AUTO button F again.
• The previous automatic cleansing process is
resumed.
Automatic cleansing function: Move cleansing and
warm air dryer run for 1 minute each.
Setting water pressure
The water pressure can be set in three steps (indicated by
first, middle and last LED):
Usage
19