Uline H-5816 Manual Del Usuario página 2

1. Screw the four casters with flat washers and locking
washers into the base using provided wrench.
(See Figure 1)
Figure 1
2. Thread each bottom upright into the base.
(See Figure 2) To fully secure uprights, place
included wrench into pipe slots and tighten fully.
(See Figure 2a)
NOTE: Ends with slots should be facing up.
Figure 2a
PAGE 2 OF 9
ASSEMBLY
3. Screw an adjustable connector to the top of each
bottom upright. Make sure connectors are facing
out. (See Figure 3)
Flat Washer
Locking
Washer
4. Tighten set screws using Allen wrench to lock
adjustable connectors in place. (See Figure 4)
Figure 2
Facing
Out
Figure 3
Facing
Out
Set
Screw
Figure 4
0621 IH-5816