DJ-Tech iDance Zero Manual De Instrucciones página 4

Section 1
1. Sample volume - Control sampler output volume when playing sampler.
2. Cue - Pressing the CUE button during playback immediately return to the start point of sampler.
3. FX select - Used to select desired effects.
The Scratch effect simulates real time turntable scratching. Once the Scratch effect has been
• Scratch activated, the jog wheel may be used in the same fashion a turntable platter is used. Use the jog
wheel to simulate the scratch motion on a turntable platter and to manipulate playback.
• Filter When the Filter effect is selected it will tweak the original sound to add different tonal definition.
• Echo When the Echo effect is selected, it will add an echo to your output signal.
• Trans When the Trans effect is selected, it will simulate a real-time mixer transformer effect.
• Phase When the Phase effect is selected, phase shifting effect will be added to the output.
When the Flanger effect is selected, it distorts the output signal and creates an effect similar to
• Flanger
frequencies phasing in and out of each other.
When the Pan effect is selected, the effect will automatically pan the output from the left channel
• Pan
to the right channel.
When the Skid effect is selected, the start time and stop time of sample PLAY/ PAUSE action
• Skid will be prolonged. This function can be engaged only when effect is on sampler mode.
Operation on sampler PLAY/PAUSE can activate the skid effect.
When the Rev effect is selected, the sampler will play in reversed direction.
• Rev.
This function can be engaged only when effect is on sampler mode.
Hold LED - Hold LED can be toggled ON/OFF by pressing the FX select. When the hold function is activated (hold
LED turned on), the unit will memorize the parameter set with the jog wheel on the current effect. The memorized
parameter will be re-called when users switch back to that effect.
4. FX button - This button functions as an effect Master on/off button and is used to activate and deactivate the effects.
5. Jog wheel - Used to simulate vinyl scratching and tune effect parameter.
6. Dry/Wet Fader - Used to change the mix ratio between original and effected signal.
7. Rec button - This button is used to record a sample from sampler source which is decided by "SAMPLER ON"
switch.
• A sampler can be made only when sampler is in "PAUSE" mode or power on state.
• The sampler length is about 25secs at maximum
8. Loop button - When LOOP light is on, sampler will be played in loop mode. Otherwise sampler playback will stop at
the end of sampler.
All manuals and user guides at all-guides.com
4