Publicidad
Idiomas disponibles
Idiomas disponibles
• DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The charger and
battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging Mac Tools™ rechargeable batteries. Any other uses
may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in risk of
fire, electric shock, or electrocution.
• When operating a power tool outdoors, use an extension
cord suitable for outdoor use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
• An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. An undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating. When using more than one extension to make up the
total length, be sure each individual extension contains at least the
minimum wire size. The following table shows the correct size to
use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
All manuals and user guides at all-guides.com
Ampere Rating
More
Than
10
12
• Do not place any object on top of charger or place the
• Do not operate charger with damaged cord or plug.
• Do not operate charger if it has received a sharp blow, been
• Do not disassemble charger; take it to an authorized service
• Disconnect the charger from the outlet before attempting
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
7
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet (meters)
120V
25 (7.6)
240V 50 (15.2) 100 (30.5)
Not More
Than
0
6
18
6
10
18
12
16
16
14
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
dropped, or otherwise damaged in any way. Take it to an
authorized service center.
center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
50 (15.2)
100 (30.5) 150 (45.7)
200 (61.0) 300 (91.4)
AWG
16
16
14
16
14
12
16
14
12
12
Not Recommended
Publicidad
