Publicidad
Idiomas disponibles
Idiomas disponibles
Chargers
Your tool uses a Mac Tools™ charger. Be sure to read all safety
instructions before using your charger.
Charging Procedure (Fig. 1)
1. Plug the charger into an appropriate outlet before inserting battery
pack.
2. Insert the battery pack (F) into the charger, as shown in Figure 1,
making sure the pack is fully seated in charger. The red (charging)
light will blink continuously indicating that the charging process
has started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
FIG. 1
F
All manuals and user guides at all-guides.com
Indicator Light Operation
MCB101
x
MCB115
Charge Indicators
Some chargers are designed to detect certain problems that can arise
with battery packs. Problems are indicated by the red light flashing at
a fast rate. If this occurs, re-insert battery pack into the charger. If the
problem persists, try a different battery pack to determine if the charger
is OK. If the new pack charges correctly, then the original pack is
defective and should be returned to a service center or other collection
site for recycling. If the new battery pack elicits the same trouble
indication as the original, have the charger tested at an authorized
service center.
8
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
PROBLEM PACK OR CHARGER
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
Publicidad
