Use; Maintenance; Troubleshooting Table - BAT Base Lite Manual Para Uso Y Mantenimiento

Use and maintenance manual
7

Use

· Before making the product operational, read Cap.2 "Safety", pag.19 and Cap.4 "Intended use and
installation location", pag.21 carefully.
· Ensure there is nobody obstructing or excessively close to the product's moving parts when opening
and closing.
· Pay attention to all the warnings applied to the product, and follow all safety regulations and
instructions for use.
· It is strictly prohibited to climb on or hang/place any objects from/on the product.
· The product must always be opened from top to bottom and never vice versa, as it could break with
the risk of serious personal injuries.
· Danger of breakage, with risk of serious personal injury.
· If mould should appear, clean the fabric (Cap.8.2 "Cleaning", pag.24).
Manual awning
The awning is opened and closed by a rod attached to a manual crank.
Motorised awning
The product can be opened and closed via:
· a SWITCH installed near the product in a position providing the user with full visibility of the same during its
movement. If installed outdoors, the switch must have appropriate ingress protection.
· A REMOTE CONTROL, portable or wall mounted.
The characteristics and operation of these systems are described in the manuals, supplied as annexes, for the
requested controls, motor and automatic devices.
In the event of faults or malfunctions, contact your reseller.
8

Maintenance

· MAINTENANCE ON ELECTRICAL PARTS MUST ONLY BE PERFORMED BY QUALIFIED
PERSONNEL
· All maintenance and cleaning operations must be performed with the electrical supply disconnected.
·There is the danger of deadly electrical charges over the course of the research or of the restoration
of potential mulfunctions in the electrical part
· Before operating the structure, read instructions in Cap.2 "Safety", pag.19 carefully.
· Assembly of the components, installation and first start of the product must only be performed by
specialised and qualified technicians, and is the responsibility of the reseller and/or manufacturer.

8.1 Troubleshooting Table

· All safety requirements must be followed in the event of faults or troubleshooting.
For faults and errors not listed in the following tables, contact Technical Support.
MANUAL AWNING
PROBLEM
Fabric does not roll up evenly (forms
cone)
05/09/2019 rev.04
All manuals and user guides at all-guides.com
CAUSES
Arms not symmetrical
Fabric not of even thickness
Base Lite
SOLUTIONS
Contact Technical Support
Roll up the fabric completely
23