Cleaning; Scheduled Maintenance - BAT Base Lite Manual Para Uso Y Mantenimiento

Base Lite
MOTORISED AWNING
Without electronic control unit
PROBLEM
The fabric does not roll up completely
The awning does not open completely
The motor is very noisy
The motor stops after 4-5 minutes of
continuous operation
Fabric does not roll up evenly (forms
cone)
With electronic control unit
PROBLEM
The product does not move
The product does not close in the event
of strong wind
The product does not close in the event
of heavy rain
The product opens or closes by itself,
with the remote control
The product moves discontinuously
moves per 50cm, then it stops)

8.2 Cleaning

· All cleaning operations must be performed with the electrical supply disconnected.
· Clean monthly, or when required.
· Qualified personnel are not required for ordinary cleaning operations.
· Using ladders, trestles or other similar equipment for cleaning must only be performed by specialised
personnel, who must follow applicable health and safety legislation and use appropriate PPE such as
safety harnesses etc.
· Do not use organic solvents, ammonia or hydrocarbons.
· Avoid the use of abrasive products.
Cleaning the fabric is essential to protect against the formation of mould due to dust or other material deposited
on the fabric; this can be performed by vacuuming up the dust, or using a damp cloth or sponge with warm water.
Dry the fabric before cleaning.
Cleaning of the aluminium components may be performed with water and neutral detergent.

8.3 Scheduled maintenance

· All maintenance operations must be performed with the electrical supply disconnected.
· Qualified personnel are not required for ordinary maintenance operations.
24
All manuals and user guides at all-guides.com
CAUSES
Incorrect end stop regulation
Motor crown wheel shifting during
operation
Wiring error
Faulty motor
Motor thermal cutout
Arms not symmetrical
Fabric not of even thickness
CAUSES
Damaged fuse
Wiring error
Wind sensor activated
Rain sensor activated
Remote control's low batteries
Damaged fuse
Damaged anemometer
Damaged fuse
Damaged rain gauge
Low batteries
Damage remote control
Radio interference
Damaged anemometer
Use and maintenance manual
SOLUTIONS
Contact Technical Support
Contact Technical Support
Contact Technical Support
Let the motor cool down for a few
minutes
Contact Technical Support
Roll up the fabric completely
SOLUTIONS
Contact the Assistance
Wait for the wind to stop
Wait for the rain to stop
Change the batteries of the remote
control
Contact the Assistance
Contact the Assistance
Change the batteries of the remote
control (see the instructions
concerning the controls)
Change the remote control
Contact the Assistance
Contact the Assistance
rev.04 05/09/2019