Coalesse Massaud Instrucciones De Montaje página 7

Back Cushion Replacement
1.
Insert a flat head screw driver under the outer back shell and pry it off. Start at the
corner and pry around the edge until the part is free. (Pry at
2.
Remove the 4 back mounting bolts using a Torx T-40 driver. Lift the back upwards
until it's free and set it aside.
3.
Slide the new back assembly down into place and align the 4 mounting holes.
4.
Insert the 4 new mounting bolts and tighten to 90 in-lbs (10 Nm).
5.
Next, install the outer back shell by aligning the top 3 ribs on the outer back shell
with the slots inside the inner back shell. Once aligned, gently press on the outer
back shell until it is captured by the spring clips, but do not push them all
the way in.
6.
Continue to work down the back shell, aligning the ribs and
pressing them into the slots/clips. Once all of the ribs have been
inserted, press the back shell on completely so there are no gaps
between the inner and outer back shells.
2
NOTE: Loop Arm style chair shown. Replacement
procedure identical for Integrated Arm style chair.
NOTE: Mid Back style chair shown. Replacement
procedure identical for Low Back style chair.
points indicated).
3
1
SLOT
4
RIB
Page 7 of 44
7960573 Rev B