Denon AVR-2803 Instrucciones De Operación página 12

ENGLISH
2
Switch to the Delay Time screen.
3
Select the desired unit, meters or feet.
Select (darken) the desired units, "Meters" or "Feet".
4
Once "Meter" or "Feet" is selected in Step 3,
the Delay Time screen appears automatically.
5
Select the speaker to be set.
6
Set the distance between
the center speaker
listening position.
The distance changes in
units of 0.1 meters (1 foot)
each time the button is
pressed. Select the value
closest to the measured
distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
Please note that the difference of distance for every speaker
should be 6.0 m (20 ft) or less. If you set an invalid distance,
a CAUTION notice, such as screen right will appear. In this
case, please relocate the blinking speaker(s) so that its
distance is no larger than the value shown in highlighted line.
7
Enter the setting.
The System Setup Menu reappears.
The AVR-2803 automatically sets the optimum surround delay time for the listening room.
NOTES:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values
(see pages 9, 10).
12
Example: When "Meters" is selected
and
Example: When the distance is set to
3.6 m for the center speaker
Setting the channel level
• Use this setting to adjust so that the playback level between the different channels is equal.
• From the listening position, listen to the test tones produced from the speakers to adjust the level.
• The level can also be adjusted directly from the remote control unit. (For details, see page 27.)
1
At the System Setup Menu select "Channel Level".
2
Switch to the Channel Level screen.
3
Select "Test Tone".
4
Select the mode.
Select "Auto" or "Manual".
• Auto:
Adjust the level while listening to the test tones
produced automatically from the different speakers.
• Manual:
Select the speaker from which you want to produce the
test tone to adjust the level.
5
Select "Test Tone Start".
6
Select "Yes".
Example: When the "Auto" mode is selected