Your Product; Introduction; Package Contents; Getting Started - Marmitek IR Control 10 Modo De Empleo

3 Your product

3.1 Introduction

Congratulations on your purchase of the IR Control 10™. With it you can extend the IR
(infrared) signals of remote controls. The IR Control 10™ makes it possible to operate
A/V devices while these are in a closed cupboard or when your A/V equipment is out of
sight.

3.2 Package contents

1 x IR Module
1 x IR Receiver
2 x IR Extension cable with two IR emitter LEDs
1 x Power adaptor
1 x Manual

4 Getting started

4.1 How it works

Locate your A/V equipment in a closed cupboard, TV cabinet or even in another room.
The IR receiver must be installed in view of your own remote control. Stick the IR LEDs
on your A/V equipment and conceals the IR main module neatly. Point the remote
control at the IR receiver in order to send the appropriate command to the IR LEDs (via
the IR main module). These will then immediately pass this onto the A/V equipment.
The IR Control 10™ is made up of three main components;
1. IR Receiver
The IR Receiver receives infrared commands from your remote control and sends
these onto the IR Module.
2. IR Module
The IR Module receives infrared commands from the IR Receiver, processes
them and sends them onto all connected IR Extender Cables.
3. IR extension cable with two emitter LEDs
The IR extension cable receives the infrared commands from the IR Module and
converts them via the IR LEDs into infrared signals. The IR emitter LEDs have a
limited range and therefore they have to be stuck accurately on the IR receiver
window of the A/V device you want to operate.
IR Control 10™ 5