Pentair MICROBRITE Guia Del Usuario página 16

12
IMPORTANT NOTICE: THE MICROBRITE COLOR AND WHITE LED
LIGHT IS A NON-SERVICEABLE LIGHT. THE COMPLETE
The following removal and installation instructions describe how to remove and install the
MicroBrite light assembly.
IMPORTANT NOTICE: THE MICROBRITE LIGHT IS A
NON-SERVICEABLE LIGHT. THE COMPLETE LIGHT ASSEMBLY
Failure to bring the pool or spa's electrical system up to code requirements before
installing the underwater light will create an electrical hazard which could result in
death or serious injury to pool users, installers, or others due to electrical shock, and
may also cause damage to property.
Switch off electrical switch or circuit breaker at the source,
1.
2. Remove Junction Box or Transformer cover. Disconnect the light wires and
attach a fish tape to the existing light power cord. This will assist in pulling the
replacement light power cord through the conduit back to the junction box.
Remove the MicroBrite light assembly from the pool or spa water: Using
3.
the provided installation tool (P/N 602158), rotate the light assembly counter-
clockwise 1/8 of a turn to release the light from the wall fitting.
4. Slowly pull the light and attached power cord (with attached fish tape) out of
the wall fitting. Pull the light's power cord and fish tape out of the wall fitting and
place the light on the deck.
5. Attach the new light power cord to the fish tape and carefully feed the fish tape
and cable to the junction box.
Install the light into the wall fitting: See page 6 and 9 for light installation
6.
instructions.
Connect the two (2) conductors to the corresponding circuit wires in the
7.
Junction Box: See page 10 for light wiring instructions.
8. Final check: See page 10 for final check instructions.
MicroBrite Color and White Light Installation and User's Guide
LIGHT ASSEMBLY MUST BE REPLACED.
MUST BE REPLACED.