Pentair MICROBRITE Guia Del Usuario página 4

iv
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
THE MICROBRITE™ COLOR AND WHITE LED LIGHT AND WALL FITTING
FORM A COMPLETE NON-METALLIC LOW VOLTAGE LIGHTING SYSTEM.
THIS CONFIGURATION DOES NOT REQUIRE BONDING OR GROUNDING
WHEN POWERED BY A POOL RATED ISOLATION 100 WATT OR 300 WATT
TRANSFORMER (LISTED ON PAGE 1) AND INSTALLED IN COMPLIANCE WITH
THE CURRENT NATIONAL ELECTRIC CODE (NEC).
UNBONDED LIGHTING NEC PROVISIONS: When the UL listed non-metallic
MicroBrite Light low voltage lights are used. The current NEC provides an
exception to luminaire bonding and grounding in Article 680.6 and 680.23
POOL WATER BONDING NEC PROVISIONS : For Pool Water Bonding required by
NEC Article 680.26C, concrete pools are considered conductive (refer to 680.26
(b)(1) due to the porosity of concrete and the bonding of rebar. No additional
bonding is required.
POOL AND SPA FIXED LUMINAIRES: Follow these guidelines when installing
or replacing Pentair Water Pool and Spa fixed luminaires:
FOR LIGHT OPERATION, ONLY USE A SAFETY ISOLATION TRANSFORMER.
Note: Connect both wires to the corresponding circuit wires in the Junction
Box (black wire to power, and white wire to common) FIXED POOL AND SPA
LUMINAIRES SPECIFICATION: 12 VAC 50/60 Hz.
IMPORTANT NOTICE: THE MICROBRITE COLOR AND WHITE LED
LIGHT IS A NON-SERVICEABLE LIGHT. THE COMPLETE LIGHT
ASSEMBLY MUST BE REPLACED.
CAUTION - DO NOT INSTALL MICROBRITE COLOR AND
WHITE LED LIGHTS WITH DIMMER SWITCHES. USE OF DIMMER
SWITCHES WILL RESULT IN PERMANENT DAMAGE TO THE
LIGHT.
MicroBrite™Color and White LED Lights are UL Approved
to be installed in a vertical position (facing up). Vertical light
installation must be installed minimum 4 inches below water
level.
Vertical Light installations are recommended only in
non-occupant areas of the pool (e.g. up-lighting a vanishing
edge overspill).
MicroBrite Color and White Light Installation and User's Guide
INSTALLERS AND INSPECTORS