Publicidad
All manuals and user guides at all-guides.com
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA_1: see p.1, No. 7)
(SATA_2: see p.1, No. 6)
(SATA_3: see p.1, No. 16)
(SATA_4: see p.1, No. 13)
(SATA_5: see p.1, No. 15)
(SATA_6: see p.1, No. 14)
USB 2.0 Headers
(9-pin USB6_7)
(see p.1 No. 18)
(9-pin USB8_9)
(see p.1 No. 17)
Infrared Module Header
(5-pin IR1)
(see p.1 No. 19)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1 No. 22)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
SATA_1
SATA_2
SATA_3
SATA_4
SATA_5
SATA_6
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
IRTX
+5VSB
DUMMY
1
GND
IRRX
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
These six Serial ATA2
(SATA2) connectors support
SATA data cables for internal
storage devices. The current
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.
This is an interface for the front
panel audio cable that allows
convenient connection and
control of audio devices.
FM2A58 Pro+
21
Publicidad
