Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Engine is running, but
no AC output is
available.
Engine runs good at
no-load but "bogs
down" when loads
are connected.
Engine will not start;
or starts and runs
rough.
Engine shuts down
when running.
Engine lacks power.
Engine "hunts" or
falters.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Cause
1.
One of the circuit breakers is open.
2.
Fault in generator.
3.
Poor connection or defective cord set.
4.
Connected device is bad.
1.
Short circuit in a connected load.
2.
Engine speed is too slow.
3.
Generator is overloaded.
4.
Shorted generator circuit.
1.
Run/Stop Switch set to "STOP" .
2.
Dirty air cleaner.
3.
Out of gasoline.
4.
Stale gasoline.
5.
Spark plug wire not connected to
spark plug.
6.
Bad spark plug.
7.
Water in gasoline.
8.
Overprimed or flooded.
9.
Excessively rich fuel mixture.
10. Intake valve stuck open or closed.
11. Engine has lost compression.
1.
Out of gasoline.
1.
Load is too high.
2.
Dirty air filter.
Carburetor is running too rich or too lean.
Correction
1.
Reset circuit breaker.
2.
Contact Sears service facility.
3.
Check and repair.
4.
Connect another device that is in
good condition.
1.
Disconnect shorted electrical load.
2.
Contact Sears service facility.
3.
See "Don't Overload the
Generator" on page 9.
4.
Contact Sears service facility.
1.
Set switch to "RUN" .
2.
Clean or replace air cleaner.
3.
Fill fuel tank.
4.
Drain gas tank and carburetor; fill
with fresh fuel.
5.
Connect wire to spark plug.
6.
Replace spark plug.
7.
Drain gas tank and carburetor; fill
with fresh fuel.
8.
Wait 5 minutes and re-crank
engine.
9.
Contact Sears service facility.
10. Contact Sears service facility.
11. Contact Sears service facility.
1.
Fill fuel tank.
1. See "Don't Overload the Generator"
on page 9.
2. Replace air filter.
Contact Sears service facility.
13
Publicidad
Capítulos
Tabla de contenido
