Getting Started; Insert Batteries - Explore Scientific WSH5001 Manual Del Usuario

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.
2. Insert 3x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
the display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Select a channel, then press TX.
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
8
] displays, or when
TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new
sensor after the batteries are installed. To manually
initiate a outdoor sensor search, press and hold
[ CHANNEL ].
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC
(atomic) reception is initiated. To manually start RCC
(atomic) reception press and hold the [
2. The receiving process duration is 7 minutes.
3. During receiving process, the RCC (atomic) signal
symbol shows:
[
4. If the RCC (atomic) receiving process is successful,
a completed RCC (atomic) symbol [
shown in the display and the date and time will
be set automatically. If it fails within 7 minutes,
RCC (atomic) setting will quit automatically. If that
] button.
.
]
] will be