Cembre B500ND Manual De Uso Y Mantenimiento página 6

WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to
maintain a balanced working position.
Before starting work on electrical equipment, please ensure that either there are
no live parts in the immediate working area or that precautions are taken for
working near live parts in accordance with EN50110-1.
Do not use this tool on or near live conductors without proper personal
protective equipment. Failure to observe this warning could result in severe injury
or death.
The tool is unsuitable for continuous use and should be allowed to cool down fol-
lowing uninterrupted, successive crimping operations. For example, having ex-
hausted a fully charged battery in one session, delay battery replacement for a
few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
IMPORTANT: In order to avoid damaging the tool, do not operate at maximum
pressure, without dies inserted in the head.
When introducing or changing dies, the battery must fi rst be removed from the tool.
The part reference includes the following:
Hydraulic crimping tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Plastic carrying case.
USB cable (Ref. to section 5).
2.1) Preparation
The tool can be easily carried using either the main handle (8) or the shoulder strap attached to the
two eyelets of the wrist strap (10) (Ref. to FIG. 6).
The tool can be held in one hand while positioning the conductor with the other.
Before starting any work, check the battery charge (Ref. to section 2.8) and recharge if
necessary, following the instructions in the battery charger user manual.
6