Installing The Axgm-01; Initializing The Axgm-01; Adjusting The Axgm-01 - Axxess AXGM-01 Instrucciones De Instalación

Idiomas disponibles

INSTALLING THE AXGM-01

With the key in the off position:

• Connect the 16-pin harness with stripped leads, and the AXGM-01 harness, into the interface.

• Connect the AXGM-01 harness to the wiring harness in the vehicle.

• If using the AXSWC, connect it after you initialize and test the AXGM-01, with the key in the

off position.

Attention! If the interface loses power for any reason, the following steps will need to be

performed again. Also, if installing an AXSWC connect it after you initialize and test the

interface/radio, with the key in the off position.

• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.

Note: If the radio does not come on within 60 seconds, turn the key to the off position,

disconnect the interface, check all connections, reconnect the interface, and then try again.

• Turn the key to the off position, and then to the accessory position. Test all functions of the

installation for proper operation, before reassembling the dash.

Chime level adjustment:

• Turn the vehicle off but leave the keys in the ignition. Open the driver's door and leave it

open; chimes will be heard.

• Wait 10 seconds, and then with a small flat-blade screwdriver, adjust the potentiometer

clockwise to raise the chime level; counterclockwise to lower the chime level.

Note: The potentiometer is located on the side of the interface where the 16-pin harness

with stripped leads is connected to.

• When the chime is at the desired level, remove the keys from the ignition. This will lock the

chime level in at its current level.

OnStar level adjustment:

• Press the OnStar button to activate it.

• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering

wheel to raise or lower the OnStar level.

• If the vehicle does not come equipped with steering wheel controls, locate the Black/Yellow

wire on the AXGM-01 harness.

• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set,

it will stay at that level until the Black/Yellow wire is tapped to ground again.

REV. 1/22/2020 INSTAXGM-01