Locating Heater - Procom Heating MNSD2TPA Manual De Funcionamiento E Instalacion Del Propietario

LOCATING HEATER

This heater is designed to be mounted on a
wall. For convenience and efficiency, install
heater:
1. Where there is easy access for operation,
inspection, and service.
2. In the coldest part of room.
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located on back panel
of heater (see Figure 5). It has been taped
there for shipping. Remove mounting bracket
from back panel.
Mounting Bracket
Figure 5 - Mounting Bracket Location
Removing Front Panel of Heater
1. Remove two screws near bottom corners
of lower front panel.
2. Pull bottom of lower front panel forward,
then down (see Figure 6).
Figure 6 - Removing Front Panel Of
Heater
200218-01A
All manuals and user guides at all-guides.com
INSTALLATION
Use only the last hole on each end of mount-
ing bracket to attach bracket to wall. Attach
mounting bracket to a wall only in one of two
ways:
1. Attaching to wall stud: This method pro-
2. Attaching to wall anchor: This method
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
1. Tape mounting bracket to wall where
clearances shown in Figure
4, page 10. If you can, provide
greater clearances from floor and
joining wall.
2. Mark screw locations on wall (see Figure
3. Remove tape and mounting bracket from
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and
spacers are in hardware package. The hard-
ware package is provided with heater.
For attaching mounting bracket to wall studs:
1. Drill holes at marked locations using 9/64"
2. Place mounting bracket onto wall. Line
3. Insert mounting screws through bracket
4. Tighten screws until mounting bracket is
www.usaprocom.com
Methods For Attaching Mounting
Bracket To Wall
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
allows you to attach mounting bracket to
hollow walls (wall areas between studs)
or to solid walls (concrete or masonry).
Marking Screw Locations
heater will be located. Make sure mount-
ing bracket is level.
WARNING: Maintain minimum
7). Note: Mark only last hole on each end
of mounting bracket. Insert mounting
screws through these holes only.
wall.
Attaching to Wall Stud Method
drill bit.
up last hole on each end of bracket with
holes drilled in wall.
and into wall studs.
firmly fastened to wall studs.
11