Procom Heating MNSD2TPA Manual De Funcionamiento E Instalacion Del Propietario página 12

6 3 / "
4
12
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Model: MNSD2TPA
10 / "
5
8
17
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Models:
MNSD3TPA, MNSD5TPA
MNSD3TPA-BB, MNSD5TPA-BB
Figure 7 - Mounting Bracket Clearances
Attaching to Wall Anchor Method
For attaching mounting bracket to hollow
walls (wall areas between studs) or solid walls
(concrete or masonry):
1. Drill holes at marked locations using
5/16" drill bit. For solid walls (concrete or
masonry), drill at least 1" deep.
2. Fold wall anchor as shown in Figure 8.
3. Insert wall anchor (wings first) into hole.
Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red key
into wall anchor. Push red key to "pop"
open anchor wings (see Figure 9).
IMPORTANT: Do not hammer anchor key! For
thick walls (over 1/2" thick) or solid walls, do
not pop open wings.
5. Place mounting bracket onto wall. Line up
last hole on each end of bracket with wall
anchors.
12
All manuals and user guides at all-guides.com
INSTALLATION
6. Insert mounting screws through bracket
1
/ "
8
7. Tighten screws until mounting bracket is
14 1 / "
2
Min.
/ "
3
8
Figure 9 - Popping Open Anchor Wings
18 / "
1
2
Min.
1. Locate two horizontal slots on back panel
2. Place heater onto mounting bracket. Slide
Stand-Out Tab
www.usaprocom.com
and into wall anchors.
firmly fastened to wall.
Figure 8 - Folding Anchor
For Thin Walls
Placing Heater On Mounting
Bracket
of heater (see Figure 10).
horizontal slots onto stand-out tabs on
mounting bracket.
Horizontal Slots
Figure 10 - Mounting Heater Onto
Mounting Bracket
Mounting
Bracket
(attached
to wall)
200218-01A