RIDGID R41121 Manual Del Operador página 31

ADJUSTMENTS
0° BEVEL ADJUSTMENT
See Figure 44.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
 Unplug the saw.
 Loosen the bevel lock knob by turning the knob
counterclockwise.
 Square the blade to the miter table as described in the
Assembly section of this manual.
 If the blade is out of square, adjust by tightening or
loosening the 0° bevel stop screw using the 3 mm leg
(long leg) of the hex key.
 Retighten bevel lock knob. Recheck blade-to-table
alignment.
Your saw has several scale indicators. After squaring ad-
justments have been made, it may be necessary to loosen
the indicators screws and reset them to zero. See Figures
19 and 20.
All manuals and user guides at all-guides.com
31 - English
HEX
KEY
0° BEVEL
STOP SCREW
Fig. 44