Finishing The Installation - Progress Lighting AirPro P250070 Manual De Instalación

Finishing the Installation

Step 1. Tuck connections neatly into ceiling outlet
box.
Step 2. Slide the canopy up to mounting bracket and
place the key hole on the canopy over the screw on
the mounting bracket, turn canopy until it locks in
place at the narrow section of the key holes. (Fig. 12)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
it drops into place.
Canopy
Canopy
Decorative
Figure 12
cover
Figure 13
Blade bracket
Attach the blades to the blade brackets using four
(4) blade screws as shown in Figure 13. Repeat
this step for the 4 remaining blades and blade
brackets. Tighten the screws securely.
Blade
bracket
screw
Figure 14
Fasten the blade assembly to the motor using the
blade bracket screws provided as shown in Figure
14. Repeat the same steps until all blades are
installed.
Blade screw
Blade
Switch housing
Motor
Figure 15
Blade assembly
Attached the switch cover to the switch housing
using the three screws from the switch housing.
(Fig.15)
Switch cover
6.