Starting Procedures - Badger WB26BCI Manual Del Operador

STARTING PROCEDURES

Do not start the unit until it has been completely assembled.
Before starting the unit, always check the oil.
1. Inspect the device before use
DANGER OF INJURY!
Do not operate the device if you find any faults. If a part has become damaged or
defective, make sure to replace it before you use the device again.
Check the safe condition of the device:
evice for leaks.
evice for visual defects.
at all parts of the device have been securely fitted.
at all safety components are in proper working condition.
DANGER OF INJURY!
Before starting work, always check the ground and remove all objects which could be
thrown by the device.
Once the machine has been set up properly and inspected, cold start the engine as follows:
Attention: The switch will always remain in the 'ON' position. To stop the unit press it to 'OFF'
and hold until it is no longer running, release and it will return to the 'On'
1. Press the priming bulb 10 times.
2. Move the choke lever to the START position.
3. Hold the machine firmly on the ground with one hand. Pull the starting cord 3-5 times until you hear
the engine start to turn over. Move choke lever to the RUN position.
WILD BADGER PO BADGERPOWER.COM 11