Hilti TE 1500-AVR Manual Del Usuario página 15

All manuals and user guides at all-guides.com
Trouble or fault
The breaker doesn't
start.
No hammering ac-
tion.
The service indicator
lights red.
The service indicator
blinks red.
The breaker
switches itself off
while running.
The breaker doesn't
achieve full power.
Printed: 02.02.2017 | Doc-Nr: PUB / 5070775 / 000 / 03
Possible cause
The generator is in sleep
mode.
The voltage provided by
the electric supply is too
high.
The power tool is too
cold.
The tool is faulty or ser-
vicing is due.
The overheating preven-
tion cut-out has been
activated.
The voltage provided by
the electric supply is too
high.
The overheating preven-
tion cut-out has been
activated.
The extension cord is
too long or its gauge is
inadequate.
Action to be taken
▶ Apply a load to
the generator by
connecting a second
power consumer (e.g.
worklight). Switch the
tool off and then on
again.
▶ Use a different power
outlet. Check the
electric supply.
▶ Bring the tip of the
accessory tool into
contact with the
working surface,
switch the power
tool on and allow it
to run. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.
▶ Have the product
repaired only by Hilti
Service.
▶ Allow the tool to cool
down. Clean the
air vents. Running
under no load is still
possible.
▶ Use a different power
outlet. Check the
electric supply.
▶ Allow the tool to cool
down. Clean the
air vents. Running
under no load is still
possible.
▶ Use an extension cord
of an approved length
and / or of adequate
gauge.
English 11