Usb Charging Port - HMDX CUBE HX-B440 Manual De Instrucciones

Power Source (Fig. 1)
This unit is supplied with an AC adapter; take the following steps to connect the adaptor.
1. Unwind the power cord of the AC adaptor to its full length.
2. Connect the AC adapter to the DC Jack (Fig. 1).
3. Plug the AC adapter into an outlet (100v – 240VAC 50/60 Hz). Connecting this system
to any other power source may cause damage to the system. For sufficient ventilation,
keep other objects at least 4 inches away from the unit.
4. To switch the unit off completely, unplug the AC adapter from the wall outlet.
Setting Clock Time (Fig. 2)
AUTOSET CLOCK
The Cube Bluetooth® clock radio is equipped with an autoset clock, meaning the clock
will automatically set itself when first plugged in. Please note: the clock will automatically
default to Eastern Standard Time and will need to be adjusted for other time zones by
manually setting the clock.
Manually Setting the Clock (Fig. 2)
1. Make sure the Cube is plugged in, but powered off.
2. Press and hold the TIME button to enter Time Setting mode. The hour will begin
flashing. Use the SET TUNE dial to adjust the hour, paying attention to the AM and
PM indicators
3. Once the hour has been set press the TIME button again and the minute will begin
flashing. Use the SET TUNE dial to adjust the minute.
4. Press the TIME button again to set the year, month and day of the week repeating the
steps above.
Display Dimmer Control (Fig. 2)
Press the SNOOZE / DIMMER / SLEEP bar to adjust the backlight intensity of clock
display. The power needs to be off to use the dimmer control.
Night Light (Fig. 2)
Press the LIGHT button on top of the Cube. The night light will turn on and can be set
to one of four levels (High, Medium, Low, Off). The night light can be operated with the
power on or off.

USB Charging Port

• This USB port is for charging only. It cannot be used to play music through the unit.
• In order to use the USB charging feature, you must have the proper cord to connect
to your device with a USB Type A connector on the other end.
4
To charge your device using the USB charging port (located on the back of the unit):
1. Connect the USB type A end of the device's cable into the USB port on the rear of the
Cube.
2. Connect the other end of the USB cable to your device to begin charging.
Volume Control (Fig. 2)
To adjust the volume, rotate the volume control clockwise or counterclockwise to the
desired level.
Listening to your device wirelessly over Bluetooth® (Fig. 2)
To listen to your music using the Bluetooth® wireless connection, you need to pair your
device with The CUBE:
1. Make sure your device has Bluetooth® capability.
2. Use the SOURCE button on the Cube to select BLUETOOTH.
3. Follow the instructions of your device to pair the unit.
4. Pair your device with the unit by selecting HMDX CUBE from your Bluetooth® listings
on your device or selecting YES. If prompted, enter "0000" as the passcode.
5. Press play on your device and use controls on the Cube to adjust desired volume.
NOTE: Once you have successfully paired your device, you typically will not need to
repeat the above steps. Please ensure the AUX cable is unplugged, the unit source is
set to Bluetooth® and your device has Bluetooth® enabled. The effective range for this
mode is approximately 30 feet.
Listening to a non-Bluetooth® audio device (Figs. 1 & 2)
1. Using the 3.5mm audio cable (included), plug in the device via the AUX audio line input
located on the rear of the Cube.
2. Plug the other end of the audio cable into the line out or headphone jack of your audio
device.
3. Press the POWER button located on top of the Cube.
4. Press the SOURCE button on the unit until the AUX icon appears on the display.
5. Press play on the connected device.
NOTE: You may need to adjust the volume on your audio device to achieve proper
volume.
Listening to the Radio/Station Presets (Figs. 1 & 2)
Note: For best reception, fully extend the wire antenna. DO NOT strip, alter or attach to
other antennas.
1. To listen to the radio, press the POWER button located on top of the Cube.
5