Setting And Using The Alarms; Battery Precautions - HMDX CUBE HX-B440 Manual De Instrucciones

2. Press the SOURCE button on the Cube until FM and station frequency appears on the
display.
3. Use the FORWARD and REVERSE buttons on the top of the unit or the SET / TUNE
dial to select desired station.
4. Press the POWER button to turn unit off.
To set/listen to station presets
1. While in radio mode, use FORWARD and REVERSE buttons or the SET / TUNE dial to
select desired station.
2. Press and hold the MEM button on the top of the Cube to add the station to your
presets. Use the FORWARD and REVERSE buttons to select the desired preset
number (1-10), then press MEM again to set.
3. To listen to station presets, press the MEM button on the unit to scroll through the
radio presets.
Sleep Feature
While listening to the Bluetooth®, radio or AUX sources, press the SNOOZE button
to activate the sleep feature. This allows you to set a sleep timer for 90, 80, 70...10, or
5 minutes. Once set, the unit will continue playing for the set length of time, then will
automatically turn off.

Setting and Using the Alarms

SETTING ALARM 1 or ALARM 2 (Figs. 1 & 2)
1. Make sure the unit is plugged in, but powered off.
2. Press and hold the desired alarm button (ALARM 1 or ALARM 2) located on the top of
the Cube. The hour will begin flashing.
3. Use the SET/TUNE dial on top of the Cube to adjust the hour, paying attention to the
AM and PM indicators.
4. Press the alarm button again and the minute will begin flashing. Use the SET/TUNE
dial again to adjust the minute.
5. Press the alarm button again to select the source. The Cube's alarm can be set to
Beep or FM using the SET/TUNE dial. The alarm cannot be set to the Bluetooth®
source.
6. Press the alarm button again and use the SET/TUNE dial to select EVERYDAY,
WEEKDAYS, WEEKENDS or ONE DAY settings.
7. Press the alarm button again to exit Alarm Setting mode.
6
TURNING OFF THE ALARM / SNOOZE OPERATION (Fig 2)
The Cube Bluetooth® clock radio is equipped with gradual wake, which means that the
alarm begins soft and slowly gets louder over the course of two minutes. This will ensure
a non-jarring wakeup.
• Press the SNOOZE bar located on the top of the Cube and the alarm will sound again
in nine minutes.
Please note: You may only press the Snooze button during the Alarm mode for one
hour (7 times). After the seventh time, the alarm will turn off and will not sound again
until the next set time.
• To turn off the alarm, press any button on the top of the unit (except Snooze).
One Day Alarm (Hotel Setting)
This alarm clock is equipped with a 1-Day Alarm feature, which allows the alarm to be
set for one day only. To activate this feature:
1. Move the HOTEL switch located on the bottom of the Cube to the ON position. Once
this switch is in the ON position, the alarm time will need to be reset. Please see the
Setting and Using the Alarms section for instruction.
Please note:
• When the 1-Day alarm feature is activated, the alarm will only sound once. Once the
alarm is turned OFF, it will not sound again until the alarm is reset.
• When setting the alarm for a 1-Day alarm, you will be prompted to set the hour,
minute, and alarm source, but will NOT be prompted to set the 7, 5, or 2-day alarm as
this feature will be disabled for both alarms.

Battery Precautions

• Use only the size and type of batteries specified.
• When installing batteries, observe proper +/- polarities. Incorrect installation of battery
may cause damage to the unit.
• If the unit is not going to be used for a long period of time, remove batteries to prevent
damage due to possible battery leakage.
• Do not dispose of batteries in fire. Batteries may explode or leak.
This product contains small parts that may present a choking hazard for young children.
Caution: All servicing of this product must be performed by authorized HMDX Service
Personnel only
7