Troubleshooting - Snapper XD ESXD19PWM82 Manual De Utilización

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
Problem
Handle is not in
position.
Mower is not
starting.
Mower is cutting
grass unevenly.
Mower is not
mulching properly.
Mower is hard to
push.
Mower is not
bagging properly.
Mower is vibrating
at higher speed.
Motor stops while
cutting.
If these solutions do not solve the problem contact your authorised service dealer.
English (original instructions)

TROUBLESHOOTING

Possible cause
Carriage bolts are not
seated properly.
Battery is low in charge.
Battery is either inoperable
or will not take a charge.
Lawn is rough or uneven
or cutting height not set
properly.
Wet grass clippings are
sticking to the underside of
the deck.
High grass, rear of mower
housing and blade are
dragging in heavy grass, or
cutting height too low.
Cutting height is set too low.
Blade is unbalanced,
excessively or unevenly
worn.
Motor shaft is bent.
Cutting height is set too low.
Battery has no power.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Charge the battery.
Replace the battery.
Move the wheels to a higher
position. All wheels must be
placed in the same cutting height
for the mower to cut evenly.
Wait until the grass dries before
mowing.
Raise the cutting height.
Raise the cutting height.
Replace the blade.
Stop the motor, remove switch key
and battery, disconnect the power
source, and inspect for damage.
Have it repaired by an authorised
service center before restarting.
Raise the cutting height.
Charge the battery.
11
Solution