Troubleshooting - Snapper ESXDST82 Manual Del Usuario

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
PRobLEM
String will not advance when
using the bump-feed head.
Grass wraps around shaft
housing and string head.
Motor fails to start when
switch trigger is depressed.
English (original instructions)

TRoUbLESHooTING

PoSSIbLE cAUSE
String is welded to itself.
Not enough string on
spool.
String is worn too short.
String is tangled on
spool.
Cutting tall grass at
ground level.
Battery is not secure.
Battery is not charged.
Shaft not connected
completely.
SoLUTIoN
Lubricate with silicone spray.
Install more string. Refer to
string replacement earlier in this
manual.
Pull string while pressing line
release button.
Remove
and rewind. Refer to string
replacement
manual.
Cut tall grass from the top down
to prevent wrapping.
To secure the battery pack,
make sure the latch on bottom
of the battery pack snaps into
place.
Charge
according to the instructions
included with your model.
Make sure lower shaft is fully
seated in shaft coupler on upper
shaft and secure shaft coupler.
9
string from spool
earlier in this
the battery pack