Instruction manual
All manuals and user guides at all-guides.com
Added up time measurement
Use the button A in order to start and stop the chronograph. Use the button A again in order to continue to count the time
and to stop it anew. The adding up of the time can be pursued in this way. Use the button B to reset the chronograph for the
minutes, the seconds and the tenths of a second.
Split time measurement
Use the button A in order to start the chronograph. Use the button B in order to show the split time (the time measurement
continues to run in the background). Use the button B in order to catch up the time (the 3 chronograph hands will be
updated in fast mode onto the measured time which went on running). Use the button A in order to stop the chronograph
and to show the end time.
Setting the chronograph hands
To ensure that all chronograph hands are adjusted to the 0 position, a full initialisation must be performed after the hands
have been set. Each counter must be set once. To do this, pull the crown out to position 2. All chronograph hands will set
themselves into either the correct or the incorrect zero position. Please press button A and B at the same time, for at least 2
seconds. The second counter hand will rotate through 360° and the correction mode has been activated.
Start by pressing button A to set the chronograph second counter to 0. To switch to the 1/10th chronograph second counter
(totalizer at 6H), press button B once. Press button A until this chronograph counter has been aligned. To switch to the
chronograph minute counter (totalizer at 9H), press button B once. Press button A until this chronograph counter has been
aligned. To complete the alignment of the chronograph counters, return the crown back to the starting position of 0.
Model: R20900 Stavanger
Quarz caliber swiss made
ATTENTION: Do not set the date between 9.00 pm and
1.00 am as the date might not change automatically the
following day.
Date and time setting
Pull the crown carefully to position 1 and set the date by tur-
ning it counter clockwi se. Pull the crown carefully to position
2 and set the time by turning it clockwi se. Once finished push
the crown carefully back in to place.
Using the chronograph
Basic function
Use the button A in order to start and stop the chronograph.
You can adjust the chronograph counter on the 9 for the mi-
nutes and on the 12 for the tenths of a second. Use the button
B to reset the chronograph for the minutes, the seconds and
the tenths of a second.